Skip to end of metadata
Go to start of metadata

Agenda

  • Design cycle check in
    • Progress on goals? On Track or not?
      • Brakes:
        • Looking at calipers. Can't really find smaller calipers
        • Pedal box spacing and adjust-ability under way
        • Brake maintenance: bleeding tomorrow (10/29/18)
        • Waiting on crush washers
      • Suspension/Chassis
        • Preliminary Rockers
        • Toe link in CAD
        • Still need to figure out steering geometry
        • Put points in OptimumK (transient analysis)
      • Aero and Composites
        • First test coupons this week for drag study - molds created by Kian already
        • Temporary (2 wk) ANSYS licenses to be installed on Monday
        • Grounding test to be done early this week
        • Airfoil Analysis to be pushed back to end of this coming week
        • First years to learn CFD
        • Around .5 week behind right now due to members being busy
      • Accumulator
        • Mounting points located +tubes
        • service section hashed out
        • prototype of segment done
          • temperature sensing
        • Testing structural PCB
        • Batteries!
        • Box CAD well under way
      • Enclosures
        • Annie to work on packaging instead of dashboard
        • Tupperware?
      • Testing
        • Waterjet broken  no garolite yet
        • 3 point bend tester is basically done
        • Garolite box testing
      • Anil subteam
        • documenting Mk3
        • being transparent with expectations
      • Transmission
        • Chain is on
        • Need to define testing goals
        • More hashed out details for transmission
          • force calcs
          • mounting distance
          • hardware specifics
        • Gear ratio
          • MF-tyre implementation
          • Compare to hunter's script
  • Mk3 Updates
    • Test Day Saturday!
      • Manual inspections between each test
      • Document document document
      • Successful Precharge
      • Spin Wheels freely
      • spin wheels on ground
      • Driving forward, nominal stop
      • Minimum turning radius
    • Make sure systems are up and running
      • Brakes
        • Figuring out brake bias
      • Suspension/Chassis
      • Transmission (Wheels)
      • Cooling
      • Accumulator
        • Mock endurance race. Measure actual capacity
      • Remove any electrical testing
    • Potential Testing that can be done
    • Drive Day vs. Testing Day
      • being deliberate about testing
      • Max as a tester, not as a driver
  • Chassis review
  • LPB Clean up and organization
  • Mechanical Bonding
    • cookies!
    • mozzarella sticks 
  • No labels