Skip to end of metadata
Go to start of metadata

10/06/2018

Agenda:

  • MK-III Timeline
    • Check firmware
    • Solve IMD issue 
      • Corey thinks the code looks fine
      • Could be an internal accumulator issue
      • Hoppe will check this afternoon
      • May have to pull accumulator out again
  • Thursday Design Review
    • "Kick off"
    • Not for Research since it might be too early 
  • Sub team check ins
    • Research
      • Handed out tasks
      • Sol → Motor Controller
      • JK → Serial Coms. Integrating CAN for STM
    • Sensors
      • Will finished brake pressure line
        • Needs mechanical calibration 
      • Bryce working on suspension strain
        • A+
      • Mark working on brake temp
        • Needs some direction
      • Dhara working on COM board
        • Running through tutorials
      • Dan working on potential CAN bluetooth app
    • Functional
      • Going well.

10/13/2018

Agenda:

  • Design review
    • Steering wheel 
      • one circuit for the button with different resistors or something to do one-wire analog
      • Tip ring ring sleeve 
    • Wheel speed
      • Mounting on MK-III may be an issue 
    • Format of DR
      • Top level→specifics 
  • Block Diagram
    • Needs to be more clear
  • Timeline
    • In a good place
    • 3 weeks for schematic and 2 weeks for block diagram (tentative)
    • Some people need to be led through it 
    • Lucky is available to remotely helpl
  • Next meeting
    • Set them off in KiCad
    • Refresher on Github on just the bare basics
  • MK-III
    • Found BMS code
      • Issue with voltage reading - likely a disconnect underneath the service section

10/20/2018

Attendees:

Lucky Jordan

Alexander Hoppe

Will Fairman

Corey Cochran-Lepiz 

Anil Patel

10/27/2018

Atendees:

Alexander Hoppe
Will Fairman

Lucky Jordan

Corey Cochran-Lepiz

Agenda:

  • Conference room
    • Snazzy motions with camera
  • Schematic DR on Thursday
    • Check ins on Monday







  • No labels